Welcome to Alaska House

New & Noteworthy

Alaska and house plans

[GOOGLEFREETEXTUNIQ-5-7phosphate swelling allergies]

Section Navigation Section Navigation. A wide variety of birdhouse plans are available. As long as you remember the 11 important points listed above and are careful to use the correct dimensions, any birdhouse plan will work. The following plans are suitable for Alaskan birds. Use the height, width, and entrance hole measurements in the Birdhouse Dimension Table to adapt these two plans for any species of cavity-nesting bird.

Use a section of birch, aspen, or spruce log from your firewood pile. Be sure to select a log large enough for the inside cavity dimentions required by the bird that will use the house, alaska and house plans.

Cut the bottom of the log section off squarely and cut the top at alaska and house plans slight angle to allow a pitched roof. Saw the log in half vertically so that the pitched top is divided into an upper and lower section.

Hollow out the inside of the two halves to the required dimentions sensory sleeping aids a chisel or chainsaw. Leave the bottom of the log halves solid, but hollow out the top completely. Drill an entrance hole through the front log section.

Be sure to alaska and house plans the hole the correct size and at the proper height alaska and house plans the cavity floor. Rejoin the two halves using glue, wire, or latches. Try to seal the crack to reduce drafts through the cavity. Cut a roof for the house from a log section of board 2 inches larger in diameter than the joined sections.

Hinge the roof to the top of the hollowed log with a brass or galvanized steel hinge, so that the roof extends over the edges at least 1 inch on all sides. Place latches on each side of the roof so that predators will adrenal gland asthma be able to pry off the roof.

Attach your split log birdhouse to a post or tree using a lag bolt and spike nail. Spacing blocks will allow lamisil ointment side affects to open the lid easily. Cut the proper size entrance hole at the correct distance below the top.

Be sure to bevel the top so the roof will fit properly. Cut the top edge of the side boards at an anle so the roof can be pitched. Back Cut 1 The backboard must be 1 inch taller than the front to allow a sloped roof. Be sure to bevel the top of the board so the roof will fit properly. Roof Cut 1 Cut the roof large enough to overlap all four sides by 1 inch. Larger or smaller boards will alter the size slightly. When the box is constructed, the bottom should be surrounded by the other boards to prevent water from seeping in.

Nail the box together so that the bottom board is enclosed by the four sides. Hinge the roof on one side so that it extends beyond the edges of the four sides of the nest box. Attach the nest box to a post, tree, or house using a lag bolt and spike nail, alaska and house plans.

The spacing blocks will allow you to open the box easily. Alaska Department of Fish and Game, alaska and house plans.

 

Alaska and house plans

.